Now Reading
Particle Accelerators May Soon Be Within Reach of the Developing World

Particle Accelerators May Soon Be Within Reach of the Developing World

Much like the computer chips that made Gordon Moore famous, the accelerator on a chip could dramatically shrink the size of accelerator technology to benefit society. Credit: SLAC National Accelerator Laboratory)

In the last decade, tabletop accelerators have inched closer to commercial viability because of a method called plasma wakefield acceleration. And that’s good news for India.

Much like the computer chips that made Gordon Moore famous, the accelerator on a chip could dramatically shrink the size of accelerator technology to benefit society. Credit: SLAC National Accelerator Laboratory)
Much like the computer chips that made Gordon Moore famous, the accelerator on a chip could dramatically shrink the size of accelerator technology to benefit society. Credit: SLAC National Accelerator Laboratory)

In the last decade, tabletop accelerators have inched closer to commercial viability because of a method called plasma wakefield acceleration. Recently, a peer-reviewed experiment detailing the effects of this method was performed at the University of Maryland (UMD) and the results published in the journal Physical Review Letters (arXiv pre-print). A team-member said in a statement: “We have accelerated high-charge electron beams to more than 10 million electron volts using only millijoules of laser pulse energy. This is the energy consumed by a typical household lightbulb in one-thousandth of a second.” Ten MeV pales in comparison to what the world’s most powerful particle accelerator, the Large Hadron Collider (LHC), achieves – a dozen million MeV – but what the UMD researchers have built doesn’t intend to compete against the LHC but against the room-sized accelerators typically used for medical imaging.

In a particle accelerator like the LHC or the Stanford linac, a string of radiofrequency (RF) cavities are used to accelerate charged particles around a ring. Energy is delivered to the particles using powerful electromagnetic fields via the cavities, which switch polarity at 400 MHz – that’s switching at 400 million times a second. The particles’ arrival at the cavities are timed accordingly. Over the course of 15 minutes, the particle bunches are accelerated from 450 GeV to 4 TeV (the beam energy before the LHC was upgraded over 2014), with the bunches going 11,000 times around the ring per second. As the RF cavities switch faster and are ramped up in energy, the particles swing faster and faster around – until computers bring two such beams into each other’s paths at a designated point inside the ring and BANG.

A wakefield accelerator also has an electromagnetic field that delivers the energy, but instead of ramping and switching over time, it delivers the energy in one big tug.

First, scientists create a plasma, a fluidic state of matter consisting of free-floating ions (positively charged) and electrons (negatively charged). Then, the scientists shoot two bunches of electrons separated by 15-20 micrometers (millionths of a metre). As the leading bunch moves into the plasma, it pushes away the plasma’s electrons and so creates a distinct electric field around itself called the wakefield. The wakefield envelopes the trailing bunch of electrons as well, and exerts two forces on them: one along the direction of the leading bunch, which accelerates the trailing bunch, and one in the transverse direction, which either makes the bunch more or less focused. And as the two bunches shoot through the plasma, the leading bunch transfers its energy to the trailing bunch via the linear component of the wakefield, and the trailing bunch accelerates.

A plasma wakefield accelerator scores over a bigger machine in two key ways:

  • The wakefield is a very efficient energy transfer medium (but not as much as natural media), i.e. transformer. Experiments at the Stanford Linear Accelerator Centre (SLAC) have recorded 30% efficiency, which is considered high.
  • Wakefield accelerators have been able to push the energy gained per unit distance travelled by the particle to 160 GV/m (an electric potential of 1 GV/m corresponds to an energy gain of 1 GeV/c2 for one electron over 1 metre). Assuming a realistic peak accelerating gradient of 100 MV/m, a similar gain (of 160 GeV) at the SLAC would have taken over a mile.

There are many ways to push these limits – but it is historically almost imperative that we do. Could the leap in accelerating gradient by a factor of 100 to 1,000 break the slope of the Livingston plot?

Could the leap in accelerating gradient from RF cavities to plasma wakefields break the Livingston plot? Source: AIPCould the leap in accelerating gradient from RF cavities to plasma wakefield accelerators break the Livingston plot? Source: AIP

In the UMD experiment, scientists shot a laser pulse into a hydrogen plasma. The photons in the laser then induced the wakefield that trailing electrons surfed and were accelerated through. To reduce the amount of energy transferred by the laser to generate the same wakefield, they made the plasma denser instead to capitalise on an effect called self-focusing.

A laser’s electromagnetic field, as it travels through the plasma, makes electrons near it wiggle back and forth as the field’s waves pass through. The more intense waves near the pulse’s centre make the electrons around it wiggle harder. Since Einstein’s theory of relativity requires objects moving faster to weigh more, the harder-wiggling electrons become heavier, slow down and then settle down, creating a focused beam of electrons along the laser pulse. The denser the plasma, the stronger the self-focusing – a principle that can compensate for weaker laser pulses to sustain a wakefield of the same strength if the pulses were stronger but the plasma less dense.

The UMD team increased the hydrogen gas density, of which the plasma is made, by some 20x and found that electrons could be accelerated by 2-12 MeV using 10-50 millijoule laser pulses. Additionally, the scientists also found that at high densities, the amplitude of the plasma wave propagated by the laser pulse increases to the point where it traps some electrons from the plasma and continuously accelerates them to relativistic energies. This obviates the need for trailing electrons to be injected separately and increases the efficiency of acceleration.

But as with all accelerators, there are limitations. Two specific to the UMD experiment are:

  • If the plasma density goes beyond a critical threshold (1.19 x 1020 electrons/cm3and if the laser pulse is too powerful (>50 mJ), the electrons are accelerated more by the direct shot than by the plasma wakefield. These numbers define an upper limit to the advantage of relativistic self-focusing.
  • The accelerated electrons slowly drift apart (in the UMD case, to at most 250 milliradians) and so require separate structures to keep their beam focused – especially if they will be used for biomedical purposes. (In 2014, physicists from the Lawrence Berkeley National Lab resolved this problem by using a 9-cm long capillary waveguide through which the plasma was channelled.)

There is another way lasers can be used to build an accelerator. In 2013, physicists from Stanford University devised a small glass channel 0.075-0.1 micrometers wide, and etched with nanoscale ridges on the floor. When they shined infrared light with wavelength of twice the channel’s height across it, the eM field of the light wiggled the electrons back and forth – but the ridges on the floor were cut such that electrons passing over the crests would accelerate more than they would decelerate when passing over the troughs. Like this, they achieved an energy gain gradient of 300 MeV/m. This way, the accelerator is only a few millimetres long and devoid of any plasma, which is difficult to handle.

At the same time, this method shares a shortcoming with the (non-laser driven) plasma wakefield accelerator: both require the electrons to be pre-accelerated before injection, which means room-sized pre-accelerators are still in the picture.

Accelerators are for everyone

Physical size is an important aspect of particle accelerators because, the way we’re building them, the higher-energy ones are massive. The LHC currently accelerates particles to 13 TeV (1 TeV = 1 million MeV) in a 27-km long underground tunnel running beneath the shared borders of France and Switzerland. The planned Circular Electron-Positron Collider in China envisages a 100-TeV accelerator around a 54.7-km long ring (Both the LHC and the CEPC involve pre-accelerators that are quite big – but not as much as the final-stage ring). The International Linear Collider will comprise a straight tube, instead of a ring, over 30 km long to achieve accelerations of 500 GeV to 1 TeV. In contrast, Georg Korn suggested inAPS Physics in December 2014 that a hundred 10-GeV electron acceleration modules could be lined up facing against a hundred 10-GeV positron acceleration modules to have a collider that can compete with the ILC but from atop a table.

In all these cases, the net energy gain per distance travelled (by the accelerated particle) was low compared to the gain in wakefield accelerators: 250 MV/m versus 10-100 GV/m. This is the physical difference that translates to a great reduction in cost (from billions of dollars to thousands), which in turn stands to make particle accelerators accessible to a wider range of people. As of 2014, there were at least 30,000 particle accelerators around the world – up from 26,000 in 2010 according to a Physics Today census. More importantly, the latter estimated that almost half the accelerators were being used for medical imaging and research, such as in radiotherapy, while the really high-energy devices (>1 GeV) used for physics research numbered a little over 100.

These are encouraging numbers for India, which imports 75% of its medical imaging equipment for more than Rs.30,000 crore a year (2015). These are also encouraging numbers for developing nations in general that want to get in onexperimental high-energy physics – innovations in which power a variety of applications ranging from cleaning coal to detecting WMDs – not to mention expand their medical imaging capabilities as well.

Scroll To Top